Now start a new sketch on the XZ Plane of Part4.

Select ‘Curve Length’ to place the Work Points along the path of the sketch.

We will create a Work Point on this newly created sketch and replicate it 22 times with the use of ‘Rectangular Pattern’ Tool.

This will also make our sketch Fully Constrained.

Now we are applying constraints on our sketches to position it properly.

This offset length is equal to the radius of wire of mesh.

This will prevent them from being recognized as profiles by the 3D features. That is why we will apply a construction override on these projected edges.

We will use these edges as a reference for creating new sketch.

First we will project the edges of the other components available in the Assembly, using the ‘Project Cut Edges’ Command.

Our first sketch will be drawn on the XZ Plane of Part4.

By double clicking the Part4, we will now enter in the Part Modelling environment.

We will ‘Suppress’ this feature and make visible only one instance of the Part3.

In this Assembly, a ‘Component Pattern’ feature was applied to replicate the Part3.

Now the Part is fully constrained, there are no Degrees of Freedom left.

And finally a Mate Constraint between XZ Plane of Assembly and XZ Plane of Part4.

Next, we will apply a Mate Constraint between Z Axis of Part4 and Z Axis of Assembly.

To fully constrain it in the Assembly, we will apply Mate Constraint between Center Point of Part4 and Center Point of Assembly.

At present the newly created component is not fully constrained in the Assembly, which can be confirmed by checking the ‘Degrees of Freedom’.

We will start our work with creating a new component in the Assembly.

And we want to create 3 more new components Part4, Part5 and Part6 like this.

At present there are three components Part1, Part2 and Part3 in the Assembly.

This video will display how to create wires of mesh of our previously created model ‘Mesh of Table Fan’. This video will display how to create wires of the mesh of our previously created model 'Mesh of Table Fan'.Ĭlick the following link to get the drawing sheet of the model: - Transcription of Video Creating wires in Mesh of Table Fan-Autodesk Inventor 2013 (with caption and audio narration)

Mesh enable inventor